|
|
Command: Pline# Y, m& ~5 s- d9 c
Specify start point: 0,0+ L3 G! j3 J2 P" M9 W0 o" A
Current line-width is 0.0000
: P- Z( I; H+ M+ X( W3 aSpecify next point or [Arc/Halfwidth/Length/Undo/Width]: w
% M- ?7 {* Z3 _6 P8 |9 B0 X9 ESpecify starting width <0.0000>: ; Check width ==> 0.0 |
|
发表于 2010-4-20 08:24